Reliability-based design is relatively well established in structural design. Its use is less mature in geotechnical design, but there is a steady progression towards reliability-based design as seen in the inclusion of a new Annex D on "Reliability of Geotechnical Structures" in the third edition of ISO 2394. Reliability-based design can be viewed as a simplified form of risk-based design where different consequences of failure are implicitly covered by the adoption of different target reliability indices. Explicit risk management methodologies are required for large geotechnical systems where soil and loading conditions are too varied to be conveniently slotted into a few reliability classes (typically three) and an associated simple discrete tier of target reliability indices.
Reihe
Sprache
Verlagsort
Verlagsgruppe
Zielgruppe
Maße
Höhe: 234 mm
Breite: 156 mm
Dicke: 22 mm
Gewicht
ISBN-13
978-1-138-56178-6 (9781138561786)
Copyright in bibliographic data and cover images is held by Nielsen Book Services Limited or by the publishers or by their respective licensors: all rights reserved.
Schweitzer Klassifikation
Dr Matt Walter a Fellow of the Safety and Reliability Society and was formerly a member of the North West Branch Committee. He went on to become Controller, Safety Standards, and subsequently Controller, Safety Management Systems, at Railtrack, and was an Executive Director
Introduction
Example of reliability-based shallow foundation design
SORM analysis on the foundation of FORM results for a rock slope
Probabilistic analyses of a slope failure in San Francisco Bay mud
Reliability analysis of a Norwegian slope accounting for spatial autocorrelation
System FORM reliability analysis of a soil slope with two equally likely failure modes
Multicriteria RBD of a laterally loaded pile in spatially autocorrelated clay
FORM design of an anchored sheet pile wall
Reliability analysis of roof wedges and rockbolt forces in tunnels
Probabilistic settlement analysis of a Hong Kong trial embankment on soft clay
Coupling of stand-alone deterministic program and spreadsheetautomated reliability procedures via response surface or similar methods
Summary and conclusions
References
