Some Research Results on Bridge Health Monitoring, Maintenance and Safety

Preface
Investigation of a Software for Finite Element Model Updating of Bridges Based on Interface Technology between VC++ and MATLAB
Significant Failure Mode Identification for a CFST Arch Bridge System
Analysis of Traveling Wave Effect on Half-Through CFST Arch Bridge by Large Mass Method
Dynamic Amplification Factor Measuring of T-Girder Bridges
Resistance and Time-Variant Reliability Updating of Existing Bridge Structures Based on Proof Loads
Sensor Optimal Placement for Structural Health Monitoring Based on Stabilization Diagram
Buffeting Reliability Analysis of Long Span Concrete-Filled Steel Tube Arch Bridge during Construction Stage
Study on Vehicle-Bridge Coupling Vibration of Equal Span Girder Bridge of Different Span Number
Seismic Performance of a Multi-Span RC Highway Bridge with High Damping Rubber Bearings
A Meta-Modeling Procedure for Updating the Finite Element Model of an Arch Bridge Model
A Method for Damage Detection Based on Correlation Characteristic of Acceleration Response
Modified Formula of Estimating Fundamental Frequency of Girder Bridge with Variable Cross-Section
Experimental Research of Uniaxial Compression Bearing Capacity on Large Diameter CFST Columns
Experimental Study of Flexural Behavior of RC Beams Strengthening with BFRP Sheets
The Length Optimization of Non-Stayed Cable Segment to Low-Pylon Cable-Stayed Bridge
Seismic Performance Analysis of a Multi-Span Continuous Girder Bridge under Multi-Excitation
Impact Analysis of the Flexural Rigidity on the Frequency and Tension of the Stay Cable
Time-Dependent Shear Capability Analysis and its Application of Reinforced Concrete Simply-Supported Beam Bridge