Material Engineering and Manufacturing II

Germ-Reducing Titanium Dioxide - Silicone Rubber CompositesResearch on Microstructure and Hardness of Laser Cladding Using the Mixed Powder of Nano-TiC and Ni-Based AlloyAcoustic Metamaterial Design Method Based on Green Coordinate TransformationFabrication on a Recycled and Wide-Band Absorber by 3D PrintingMonitoring CNT-Based Composite Laminates under Monotonic and Cyclic Flexural LoadingEffects of Material Emissivity on the Radiative Characteristics of Solid SurfaceCooling Rate and Microstructural Investigation of Rapidly Solidified Spherical Mono-Sized Copper ParticlesSkin Coating Design of Stealth Aircraft Based on Infrared Characteristic AnalysisAnti-Cavitation Approach in a Bio-Inspired Throttle Valve: A Study of Using Rubber-Like MaterialsA Simplified Approach to the Failure Probability Assessment of Thermally Stable Diamond Composite Rock Cutting TipsStudy on the Dispersion of Aramid Pulp in Epoxy Resin SystemRelationship between Crystallization Behavior and Mechanical Performance of F-III Fibers under Different Tensions in Supercritical Carbon DioxideStudy on the Crystallization Behavior of PAN Fibers during Hot-Drawing Process in Supercritical Carbon Dioxide Fluid with Different StrainDetection of Graphene Materials in FibersCharacteristic Enhancement of InGaN-Based Light Emitting Diodes Grown on Pattern Sapphire SubstratesLow Energy-Consumption Inverted Orange Organic Light-Emitting Diodes with Reduced Efficiency Roll-OffHigh-Performance Red Phosphorescent Organic Light-Emitting Diodes Based on a Gradient-Doped Emitting LayerEnhanced Optical Absorption of Dual-Diameter Structured Silicon Nanoholes ArrayThe Potential of Graphene in Electronic ApplicationsInvestigation of Cutting Performance for NAK80 Hardened Steel under Different Assisted Machining SystemsEffect of Initial Residual Stress on Machining Deformation of a Casing PartEffects of Gases Temperature on the Viscosity and Flow Velocity of Melt in the Gas-Assisted Extrusion Forming of Plastic Micro-TubeFEM Analysis for Asymmetric Bending Roll of Roll Process in Four-High MillEffects of Substrate Parameters on the Residual Stress and Deflection of Ti-6Al-4V Walls in Additive Manufacturing ProcessDurability Test on the Bond Strength between SFRP Layer and Masonry SurfaceComparison Experimental Study on Retrofitting Methods of Partially Damaged Timber ColumnsStudy on Dynamic Mechanical Properties of Carbon Fiber Reinforced Concrete