Eco-Materials Processing and Design XVII

<ul><li>Preface, Committees, Sponsors</li><li>Synthesis and Photoluminescence Properties of SrLaAlO₄: Ti Green-Emitting Phosphor</li><li>The Influence of Multi-Factor Aging on Partial Discharge Property for Epoxy/Mica Insulation of Generator Stator Bars</li><li>Mechanical Recovery of Ni/Al₂O₃ Nanocomposites after Pre-Oxidations at High Temperatures</li><li>Effect of Reinforcement on the Tribological Behavior of CuFe-Based Composites</li><li>The Effect of the SiC Content on Electrical Properties of SiC Anti-Corona Coating for Generator</li><li>Synthesis of TiO₂-Modified Hydroxyapatite with Various Morphology by Urea-Assisted Hydrothermal Method</li><li>Effect of Degassing Treatment on the Crystalline Morphology of XLPE Insulation Used for 110kV XLPE Cable</li><li>Oxidation of Pentatitanium Trisilicide (Ti₅Si₃) Powder at High Temperature</li><li>Energy Consumption in Batch-Mode Capacitive Deionization</li><li>The Investigation of Electrical Properties for Mica/Epoxy Insulation Stator Bars during the Thermal Cycle Aging Test</li><li>Tribological Behaviors of Dense Gelcasting Nanocomposites</li><li>Dielectric Properties of Liquid Crystal Polymer Composites with High Thermal Conductivity</li><li>Effect of Silica on the Wettability and Composition of the Alumina/Aluminum Interface</li><li>Photoluminescence Properties of the Magnetoplumbite-Type BaMg₆Ti₆O₁₉:Mn⁴⁺ and Spinel-Type Mg₂TiO₄:Mn⁴⁺</li><li>Cationic Distribution and Electrical Properties of Ni_0.6Mn₂Si_0.4-xAl_xO₄ (0?<i>x</i>?0.04) NTC Thermistor</li><li>Fabrication and Characterization of Barium Doped Ceria Nanopowders by a Solvothermal Processing</li><li>Effects of Additives Content on the Properties of Porous SiC Ceramics</li><li>Orientation Dependence of Flow Behavior of Mg Single Crystal</li><li>Influence of Heater Diameter on the Temperature Distribution and Melt Convection in a Directional Solidification System for Mono-Like Silicon Growth</li><li>Synthesis and Characterization of CoMn₂O₄ Nanopowders by a Reverse Micelle Processing</li><li>Mechanical and Thermal Properties of Al₂O₃-Filled Epoxy Composites</li></ul>