Pipeline Design for Water Engineers
3rd Edition
Published on 1. June 1989
279 pages
978-0-08-087031-1 (ISBN)
Description
"... the book is at its best in the design and analysis sections and could stand on these alone as a well-stocked handbook with copious references for further study," commented the Journal of the National Water Council after publication of an earlier edition of Pipeline Design for Water Engineers. This classic monograph has been revised and updated to take account of new developments in the field. Recent research in cavitation and flow control has prompted additional sections to be added. There are also new sections on supports to exposed pipes and secondary stress. Additional references and a new layout make up this edition. Some sections appearing in previous editions, noteably on pipe network systems analysis and optimization have been ommitted as they were considered more appropriate in the author's parallel book ``Pipeflow Analysis'' (Developments in Water Science, 19).
More details
Series
Edition
3rd Revised ed.
Language
English
Place of publication
San Diego
Netherlands
Product notice
Windows
ISBN-13
978-0-08-087031-1 (9780080870311)
Copyright in bibliographic data and cover images is held by Nielsen Book Services Limited or by the publishers or by their respective licensors: all rights reserved.
Schweitzer Classification
Other editions
Additional editions
D.J. Stephenson
Pipeline Design for Water Engineers: Volume 40
Book
06/1989
3rd Edition
Elsevier
€54.55
Article exhausted; check different version
Previous edition
Content
1. Economic Planning. Introduction. Pipeline economics. Basics of economics. Balancing storage. 2. Hydraulics. The fundamental equations of fluid flow. Flow head loss relationships. Minor losses. Pressure and flow control in pipes. Types of valves. Cavitation in control valves. 3. Pipeline System Analysis and Design. Network analysis. Optimization of pipeline systems. 4. Water Hammer and Surge. Rigid water column surge theory. Mechanics of water hammer. Elastic water hammer theory. Protection of pumping lines. 5. Air in Pipelines. Introduction. Problems of air entrainment. Air intake at pump sumps. Air absorption at free surfaces. Hydraulic removal of air. Air valves. Head losses in pipelines. Water hammer. 6. External Loads. Soil loads. Superimposed loads. 7. Concrete Pipes. The effect of bedding. Prestressed concrete pipes. 8. Steel and Flexible Pipe. Internal pressures. Tension rings to resist internal pressures. Deformation of circular pipes under external load. Stress due to circumferential bending. Stiffening rings to resist buckling with no side support. 9. Secondary Stresses. Stresses at branches. Stresses at bends. The pipe as a beam. Temperature stresses. 10. Pipes, Fittings and Appurtenances. Pipe materials. Line valves. Air valves. Thrust blocks. Forces induced by supports. Flow measurement. Telemetry. 11. Laying and Protection. Selecting a route. Laying and trenching. Thrust bores. Pipe bridges. Underwater pipelines. Joints and flanges. Coatings. Linings. Cathodic Protection. Thermal insulation. 12. Pumping Installations. Influence of pumps in pipeline design. Types of pumps. Terms and definitions. Impeller dynamics. Pump characteristic curves. Motors. Pumpstations. General References and Standards. Books for Further Reading. Appendix. Symbols for pipe fittings. Properties of pipe shapes. Properties of water. Properties of pipe materials. Conversion factors. Author Index. Subject Index.
