Resource Efficient Material and Forming Technologies

<ul><li>Preface, Scientific Committee</li><li>Chapter 1: Light Metals and Light Alloys, Properties and Processing Technologies</li><li>Mechanical Properties and Microstructure of the Magnesium Alloy Mg-6.8Y-2.5Zn-0.5Al Produced by Casting and Hot Rolling</li><li>Application and Research Twin Roll Casting-Extruding Process for Production Longish Deformed Semi-Finished Products from Aluminum Alloys</li><li>Preparation of Novel Al-Er Master Alloys in Chloride-Fluoride Melt</li><li>Closed Die Forging of Mg-Al-Zn-Ca-Y Alloys</li><li>Development of an Innovative and Quality-Focused Production Technology for Magnesium Wire</li><li>Determination of the Hot Cracking Tendency of a Twin-Roll Cast AZ31 Magnesium Alloy by Means of Gleeble Tests</li><li>Asymmetric Twin-Roll Casting of an Al-Mg-Si-Alloy</li><li>Physical Modeling Technological Regimes of Production Deformed Semi-Finished Products from Experimental Aluminium Alloys Alloyed by Scandium</li><li>Chapter 2: Latest Trends in Forging Technology</li><li>Experimental Evaluation of Cold Forging Lubricants Using Double-Cup-Extrusion-Tests</li><li>Manufacturing of Long-Length Rods of Ultrafine-Grained Ti-Ni Shape Memory Alloys</li><li>Closing of Shrinkage Cavities by Means of Open-Die Forging</li><li>Development of a Quenching-Partitioning Process Chain for Forging Components</li><li>Chapter 3: Numerical Simulation of Technological Processes</li><li>Robustness - Practice Report: Make Forming Processes more Stable</li><li>Novel Approach for the Determination of the Taylor-Quinney Coefficient</li><li>Modelling of Cooling and Recrystallization Kinetics during Self-Annealing of Aluminium Coils</li><li>Experimental Investigations of Bulge Formation for Burnishing on Plain Surfaces</li><li>Chapter 4: Current Trends in the Processing the Steel and Non-Ferrous Metals</li><li>Investigating the Influence of Bending Parameters on the Springback Behavior of Ultra-High Strength Spring Strips</li><li>Automation Tool for Quality Assurance of Long Products</li><li>Improvement of Manufacturing Technology for Thin-Walled Pipes Made of Copper Alloys</li><li>Evolution of the Microstructure of the Copper Alloy (DIN-ECu-57) in the Deformation Zone in the Process of Pressing Conform</li><li>Effect of Cooling and Isothermal Holding on the Amount of Martensite/Austenite (M/A) Constituents, Microstructure and Mechanical Properties of Microalloyed Pipeline Steel</li><li>Optimization of Tooling Design for Hot Mandrel Bending of Pipe Elbows</li></ul>