Advanced Materials Science and Technology (IFAMST-8)

<ul><li>Preface and Committees</li><li>Synthesis of MAX Phase (Cr,V)₂AlC Thin Films</li><li>Study on Preparation Process of Magnetic Abrasive Particles</li><li>Fatigue Fracture of Clay Reinforced Nylon Nanocomposites</li><li>Crack Healing Behavior of SiC Whisker Reinforced Si₃N₄ Composite</li><li>Effect of Chemical Composition on Fracture Behavior in ZrNiAl Metal Glass</li><li>Effect of Minor Addition Ta on the Thermal Stability and Corrosion Resistance of Ti-Zr-Cu-Pd Bulk Metallic Glasses</li><li>Residual Stress in Oxide on NiCrAlY Coating Evaluated by Photoluminescence Spectroscope</li><li>Preparation of Ni-P-Al₂O₃ Composite Film on Mild Steel with High Resistance to Corrosion and Wear</li><li>Effects of Minor Si Addition on Glass Formation and Thermal Stability of Ni Free Ti-Based Bulk Metallic Glass</li><li>Influence of Carbon Reinforcements on the Mechanical Properties of Ti Composites via Powder Metallurgy and Hot Extrusion</li><li>Effect of Nanosized Particles on the Mechanical Properties of Y₂O₃</li><li>Three-Dimensional Characterization of BaZrO₃ Precipitates in Y_1-xGd_xBa₂Cu₃O_7-y Prepared by TFA-MOD Using STEM-Tomography</li><li>Ti-Based Bulk Metallic Glass Composites Produced by Spark Plasma Sintering</li><li>Fabrication of Cu Nanowires and its Effect on Proliferation of Mesenchymal Stem Cells</li><li>Electrochemical Behavior of AZ Magnesium Alloy Containing Rare Earth Element</li><li>Roll-Gap Control System of Twin Roll Strip Caster Based on Feed Forward-Feedback</li><li>Improvement of Catalytic Activity of Atomized Ni₃Al Powder for Methanol Decomposition by Surface Chemical Treatments</li><li>Nanoporous Copper Dealloyed from a Nanocrystallized Ticu Alloy</li><li>Combined Experimental and Numerical Approach for Linking Microstructure and Mechanical Properties on Different Length Scales for near ?-TiAl Alloys</li><li>Development of ZnTe-Based Solar Cells</li><li>Peroxidase and Toluidine Blue-Incorporated DNA Bio-Polyion Complex Film as Biosensing Layer for Hydrogen Peroxide Determination</li><li>Dynamic Strain Ageing in a Twin-Induced Plasticity Steel</li><li>
<i>In Situ </i>Synthesis of Alumina Matrix Composites by Spark Plasma Sintering</li><li>Temperature Field Analysis of Directional Solidification of Multi-Crystalline Silicon</li><li>Rheological Model for a Nanoporous-Elasto-Hydrodynamic Composite Material</li><li>Influence of Glass Coating Thickness on Interfacial Heat Transfer Coefficient during Forming of Nickel Based Superalloys</li><li>Shear Strength Evaluation of Laminated Binderless Bamboo Composites</li><li>Effect of Crack Initiation Size on Fatigue Strength in 0.85% Carbon Steel</li><li>Application of Magnetic Field Method for Measuring Lubricant Viscosity</li><li>Fabrication of Photo-Polymerized PCL Tissue Engineering Scaffolds by Dynamic Masking Rapid Prototyping System</li><li>FEM Analysis on Thermoelectric Properties of Metal/TiO_2-x Composites with Random Distribution of Metal Powder</li><li>Improvement of Thermoelectric Properties of CuAlO₂ by Excess Oxygen Doping in Annealing</li><li>Influence of Intermittent Air Introduction on Formation of Zn Films by Mechanical Coating Technique</li><li>Detection of Delamination in GFRP and CFRP by Microwaves with Focusing Mirror Sensor</li><li>Comparison of Mechanical Properties of a Biomedical ? Titanium Alloy Added with Pure Rare Earth and Rare Earth Oxides</li><li>Mapping of Phase Distribution in Electron Holography with a Stage-Scanning System</li><li>Modeling and Simulation of Dynamic Recrystallization of GCr15 Steel Using Cellular Automaton Method</li><li>Investigation of Bonding Interface and Strength Properties in Diffusion Bonding of MgAZ31/Al6061</li><li>Analysis of Bonging Temperature and Interfacial Characterization of 3Y-TZP and SUS304 by Diffusion Bonding</li><li>The Effect of H₃BO₃ Microaddition on Microstructure of Ni/MgO Sintered Compact by Co-Precipitation Method</li><li>A Study on the Rust Removal and Retard on the Surface of the Wear Water Screw-Thread Steel Using Flame Hot Melting</li><li>Microstructure Evolution of AZ31 Magnesium Alloy in Rolling Zone</li><li>Study on the Application of Magnetic Nanoparticles as Drug Delivery Particles on the Atopic Dermatitis</li><li>A Pseudo-Binary Diagram of the (Bi,Pb)-Sr-Ca-Cu-O System</li><li>Synthesis of Spherical Carbon Nanoparticles via Sol-Gel and their Electrochemical Properties in Electrical Double Layer Capacitor</li><li>Effect of Mean Stress on Fatigue Strength of Spheroidal Graphite Cast Iron</li><li>Study on Anisotropic Mechanical Behavior at near Pre-Crack for AZ31B Sheet under Biaxial Stress</li><li>A Study on Spatial Resolution of the Microwave Atomic Force Microscope Imaging Affected by Scanning Speed</li><li>Thermal Residual Stress and Tensile Strength of UACS/Al Laminate with Different Slit Angles</li><li>Effects of Slit Patterns on the Tensile Properties of Unidirectionally Arrayed Chopped Strands Composites</li><li>Effect of Substrate on Crystallization of Sol-Gel-Derived Pb(Zr_0.52Ti_0.48)O₃ Thin Films by Microwave Annealing</li><li>Structure Simulation Calculation of Impurities B with Fe, Al or Ca in Metallurgical Grade Silicon</li><li>Effect of Microwave Irradiation on Rapid Crystallization of Ferroelectric Lead Zirconate Titanate Thin Films</li><li>Preparation of Paver Bricks Having both Water Retainability and Frost Resistance by Designing Macro Porous Structure</li><li>Optimization of Process Parameters for Unidirectional Solidification of Magnesium Alloy</li><li>Notch Effects in High Cycle Fatigue of Ti-6Al-4V</li><li>Investigation for Small Shear-Mode Fatigue Cracks in Bearing Steels</li><li>Purification of Silicon Using the Liquid Phase Migration Technique under Temperature Gradient</li><li>Formation of Nanocrystalline Si by Au-Catalyzed CH₃SiH₃ Pulse Jet CVD</li><li>Photo-Electrochemical Properties of Titanium Dioxide Thin Films Prepared by Reactive RF Sputtering Method</li><li>Nanopore Formation on SOI(100) by CH₃SiH₃ Pulse Jet CVD: SiC Growth Temperature Dependence</li><li>Estimation for Fatigue Behavior of Notched Plate with Mean Stress Effect</li><li>Hydrogen-Induced Ductility Loss in Cast Irons</li><li>Effect of Occasional Shear Loading on Fatigue Crack Growth in 7075 Aluminum Alloy</li><li>Effect of Dry-Ice Blasting on the Microstructure and Properties of Plasma-Sprayed CoNiCrAlY Coating</li><li>Morphology and Residual Stress of Ultrathin Al Films Confined by AlN Layers</li><li>A High Sensitivity 3-D Measurement Method of Minute Specimen Based on Microscope and Laser Projection</li><li>Reductive Removal of Phosphorus in Silicon Using CaO-CaF₂ Slag</li><li>Critical Current Characteristics and Flux Pinning in Fe-Based Pnictide Superconductor</li><li>Critical Current Density and Flux Pinning Properties in Superconducting MgB₂ with and without SiC Doping</li><li>Structure and Electrochemical Properties of DLC/SiC Films on the Surface of Magnesium Alloy by Plasma Immersion Ion Deposition</li><li>The Effect of Working Pressure on the Composition and Optical Properties of TiO₂ Films Bombarded by N Ion Beams</li><li>Glass-Forming Ability and Mechanical Properties of Zr-Ni-Al Bulk Metallic Glasses with High Zr Content</li><li>The Effect of Pt Addition on the Structure and Magnetic Properties of Melt-Spun Fe_80-xPt_xB₂₀Alloys</li><li>Effect of Withdrawal Rate on Defects of Upgraded Metallurgical Grade (UMG)-Silicon Prepared by Vacuum Directional Solidification</li><li>The Research of Bubble Adsorption to Purify Silicon in the Al-Si System</li><li>A Developing Method to Prepare Micro-Nanopowder by Incorporating Jet Milling and Electrostatic Dispersion</li><li>Effects of Lanthanide Substitution on the Sintering Behavior of Bismuth Titanate Ceramics Prepared by the Chemical Coprecipitation Method</li><li>Development of Silicon Nitride Porous Bodies with Micro-Macro Complex Pore Structure for the Application of the 'Bio-Filter'</li></ul>