Use of Micropiles for Foundations of Transportation Structures

In pile design, piles must be able to sustain axial loads from the superstructure without bearing capacity failure or structural damage. In addition, piles must not settle or deflect excessively in order for the serviceability of the superstructures to be maintained. In general, settlement controls the design of piles in most cases because, by the time a pile has failed in terms of bearing capacity, it is very likely that serviceability will have already been compromised. Therefore, realistic estimation of settlement for a given load is very important in design of axially loaded piles. This notwithstanding, pile design has relied on calculations of ultimate resistances reduced by factors of safety that would indirectly prevent settlement-based limit states. This is in part due to the lack of accessible realistic analysis tools for estimation of settlement, especially for piles installed in layered soil. Micropiles have been increasingly used, not only as underpinning foundation elements but also as foundations of new structures. Prevalent design methods for micropiles are adaptations of methods originally developed for drilled shafts. However, the installation of micropiles differs considerably from that of drilled shafts, and micropiles have higher pile length to diameter ratios than those of drilled shafts. Improved understanding of the load-transfer characteristics of micropiles and the development of pile settlement estimation tools consistent with the load-transfer response of these foundation elements are the main goals of the proposed research. A rigorous analysis tool for assessment of the load-settlement response of an axially loaded pile was developed in this study.