Advanced Materials, Technologies and Technological Processes

<ul><li>Preface</li><li>Chapter 1: Additive Technologies</li><li>Investigation of the Gradient Properties of Samples Obtained by Direct Laser Deposition from a Mixture of Ni/Ti Elemental Powders</li><li>Effect of Selective Laser Melting Parameters on Physicomechanical Properties of Ferromagnetic Shape Memory Ni₃₆Al₂₇Co₃₇ Alloy</li><li>Properties Investigation of Steel-TiC Composite Material Formed during Selective Laser Melting Process</li><li>Chapter 2: Modern Technological Processes</li><li>Structure and Microhardness of Constructional Steel after Ultrasonic Impact Treatment at Negative Air Temperatures</li><li>Forming of Briquettes from Iron and Plastic Waste</li><li>Welding at Low Temperatures of Structural Steels</li><li>Chapter 3: Materials with Special Properties</li><li>Surface Modification of Nickel Oxide (II) Thin Films Obtained by Gas-Phase Deposition</li><li>Influence of Crystallization Conditions on the As-Cast Structure of Fe-Mn-Si Alloy with a Shape Memory Effect</li><li>Chapter 4: Biomedical Engineering</li><li>Characterization and Penetration Profile of Resveratrol-Loaded Nanostructured Lipid Carrier (NLC) for Topical Anti-Aging</li><li>Candidal Adhesion to an Oral Obturator PMMA Resin Incorporated with Vanillin</li><li>The Antimicrobial Potential of Vanillin-Incorporated Irreversible Hydrocolloid Impression Material</li><li>Virtual and Augmented Reality for Training and Maintenance of a Multiparameter Monitor</li><li>Chapter 5: Aggregate Replacement Materials in Concrete Production</li><li>Compressive Strength of Concrete Containing Roof Tile Waste as Partial Fine Aggregate Replacement</li><li>Suitability of Conventional Ballast Mixed with Concrete Debris and Bottom Ash Waste</li><li>Effect of Crushed Clay Brick as Partial Fine Aggregate Replacement on Properties of Concrete</li><li>Sand Cement Brick Incorporating Palm Oil Clinker as Partial Replacement for Fine Aggregate</li><li>Properties of Sustainable Concrete Containing Recycled Fine Aggregate as Partial Sand Replacement</li><li>Evaluating Pre-Corrosion and Post-Corrosion of Oil Palm Shell Concrete with Non-Destructive Testing</li><li>Chapter 6: Structural Engineering and Structural Mechanics</li><li>Constitutive Law of Rectangular Concrete with Carbon Fiber Sheet Confinement</li><li>Numerical Investigation of Sectional Buckling Behaviors of Cold-Rolled Aluminium Alloy Channel Columns</li><li>Human Perception of Lightweight Floors Vibrations, New Investigations to Improve Wood Building Performances (GIVILIF Project)</li><li>Application of American Aluminum Specification in Design of Cold-Rolled Aluminum Alloy Channel Columns</li><li>Influence of Strain Hardening on Sectional Capacities of Cold-Formed Rectangular Hollow Steel Sections</li><li>Chapter 7: Geotechnics</li><li>Enhancement of Muscat's Expansive Soil Using Waste Gypsum</li><li>Comparison of the Improvement in Liquefaction Safety and Decrease in Settlements for a Severe Earthquake Following Three Soil Improvement Methods in a Sandy Soil in Chimbote, Peru</li><li>Tannic Acid/Polyvinyl Alcohol as a Wellbore Strengthener for Water-Based Drilling Fluid in Natural Gas Hydrate Reservoir</li></ul>