Symposium on Advanced Materials (17th ISAM)

<ul><li>Preface</li><li>Chapter 1: Corrosion Behaviour of Materials and Corrosion Protection</li><li>Corrosion Inhibition of Low Carbon Steel in Soil Solutions, Using Novel Schiff Base Inhibitor</li><li>Corrosion Behavior of MoSi₂ Coated Hastelloy X Utilized in Iodine -Sulfur Cycle for Hydrogen Production Application</li><li>Oxidation Resistant Nickel Aluminide Coating on Niobium Alloy C103 for High Temperature Aerospace Applications</li><li>Synthesis of Nano Ceramic Epoxy Hybrid Composite Coating on Metallic Substrate for Corrosion Protection</li><li>Chapter 2: Materials Failures and Damage Analysis</li><li>Pole Figure Analysis of Graphite Material</li><li>Investigation of Cracks on Internal Surfaces of Extruded Cold Worked Thick Walled Pipes of an Age Hardened Al-Alloy</li><li>Analysis of Malfunctioning of Centrifugal Compressor of Starter Engine of an Aircraft</li><li>Impurity Driven Embrittlement in AISI 1020 Steel during Thermal Treatments</li><li>Case Study of PVC Cables Exposed in Accelerated Thermal and Radiation Environment</li><li>Eutectic Si Accumulation in Liquid Forged A356 Alloy Wheel and its Adverse Effect on Tensile Fracture Behavior</li><li>Numerical Simulation of Viscosity Effects on Carbon Steel 90 degrees Elbow Erosion due to Sand-Liquid Flow</li><li>Vibrational Fatigue of Fuel Pipe Welds of an Aero Engine</li><li>Aging Assisted Failure of SV-40 Epoxy</li><li>Chapter 3: Composites</li><li>Shape Memory Hybrid Composites for Aerospace Applications</li><li>Advanced Body Armor Utilizing Shear Thickening Fluid Based on Nanosized Silica Particles</li><li>Design and Analysis of Multi-Layered Composite Panels for In-Plane Loadings</li><li>Development of Auxetic Braided Yarns and Study the Effects of Braid Angle and Material Modulus on the Negative Poisson's Ratio</li><li>Design of Experiments for Green Tire Tread Compound Development by Reducing Conventional Carbon with an Eco-Friendly Filler</li><li>Effect of Carbon Nanotubes Addition on the Formability of Al-CNT Composite</li><li>Chapter 4: Functional Ceramics</li><li>Study of Temperature Dependent Dielectric Spectroscopy of Cerium Doped Bismuth Calcium Cobaltite</li><li>Electrical Study of PVP/LiCo_1-xZn_xO₂ Nanoparticles Embedded Nanofibers</li><li>Cost-Effective Synthesis of Cobalt Ferrite Nanoparticles by Sol-Gel Technique</li><li>Effect of Sn Content on Structure and Piezoelectric Properties of Pb(Zr_0.35Ti_0.65)_1-xSn_xO₃</li><li>Effect of Boron Oxide Addition on Microstructure and Mechanical Properties of Slip Cast Fused Silica</li><li>Synthesis and Characterization of Nd-Doped Calcium Bismuth Cobaltites for Thermoelectric Applications</li><li>Study of Structural and Electrical Properties of CuFe-CGN for Renewable Energy Applications</li><li>Structural and Electrical Properties of Pure and Samarium Doped MgFe₂O₄ Nanoparticles for Resistive RAM Applications</li><li>Electrical Properties of Lanthanum Doped Cobalt Ferrite Nanoparticales</li><li>Structural and Electrical Properties of Rare Earth/ Ferrites: Studied for Resistive Switching Device Application</li><li>A Comparison of the Electrical Properties of Co-doped Ceria and Tri-Doped Ceria for Energy Applications</li><li>Chapter 5: Materials for Photovoltaics and Optoelectronics</li><li>Preparation Structural and Optical Analysis of Tungsten Sulphide (WS₂) Thin Film by DC-Sputtering</li><li>Green Up-Conversion Luminescence in Yb/Er Co-Doped AlN Thin Film by RF Magnetron Sputtering</li><li>Photoluminescence Study of Silver Nanoparticles Decorated on Multiwall Carbon Nanotubes (MWCNTs) by Spectroflourometer</li><li>Diamond-Like Carbon Film Deposited via Electrochemical Route for Antireflection Applications in Photovoltaic</li><li>Development of 2nd Generation Thin Film Photovoltaics Based on CZTS Absorber Layer and ZnS Window Layer</li><li>Optimizing the Morphology, Structure and Optoelectronic Properties of Aluminum Doped Zinc Oxide Thin Films Developed via Wet Chemical Synthesis</li><li>Highly Transparent N-Type TiO₂ Coatings for Self-Cleaning Glass Application</li><li>DFT Calculations Using Quantum ESPRESSO for Optical and Electronic Properties of Si Crystal</li><li>Electrospinning of Cu Doped TiO₂ Nanofibers and their Potential Application in Photoanode of Dye-Sensitized Solar Cells</li><li>A Study of Aluminum Doped ZnO Thin Films Developed via a Hybrid Method Involving Sputter Deposition and Wet Chemical Synthesis</li><li>Photoluminescence Comparison of Different Substrates on AlN: Cr Thin Films for Optoelectronic Devices</li><li>Near UV and Visible Region Photoluminescence Curves Study for AlN Thin Film and AlN Nanopowder</li><li>Spectral Splitting Optimization for Highly Efficient Hybrid Photovoltaic Devices by Using Na₃AlF₆, Y₂O₃ and TiO₂ Beam Splitter</li><li>Chapter 6: Materials for Biomedical and Environmental Engineering Applications</li><li>Effect of Sericin Additive on Cellulose Acetate Membrane Morphology and Protein Rejection</li><li>Synthesis and Characterization of Silica Coated Magnetite Nanoparticle Clusters for Viral RNA Extraction</li><li>Fabrication and Pulse Sequences Evaluation of Iron Oxides Nanoparticles as MRI Contrast Agent</li><li>Synthesis of Silver Nanoclusters from <i>Melia azedarach</i> and their Usage for Catalytic Degradation of Variable Organic Dyes</li></ul>