5th EPI International Conference on Science and Engineering (EICSE)

<ul><li>Preface</li><li>Chapter 1: Properties and Processing of Steel and Alloys</li><li>Mechanical Properties Comparison Between Induction Hardening and Rehardening of <i>Axle Shaft</i> AISI 1043 According to JIS G 0559 Standard</li><li>Strength Analysis of ST 41 Steel as Propeller Shaft with Quenching Heat Treatment and Tempering after Carburizing Carbon Media Variations</li><li>Experimental Investigation on the Effect of EDM Wire Cut Parameters on the Formation of Cr₂₃C₆ in AISI 316 Steel</li><li>Analysis of Voltage, Current Density, and Welding Speed of Flux Core Arc Welding on the Hardness and Micro-Structure of High Strength Low Alloy (ASTM A572)</li><li>The Influence of Machining Variables on the Quality of the Shaping Process on Hard Steel</li><li>Chapter 2: Composite Materials and Structures</li><li>Crashworthiness Analysis of Vehicle Crash-Box Filled with Aluminium Foam</li><li>Improving Fiber-Matrix Compatibility by Surface Modification of Coconut Coir Fiber Using White Rot Fungi</li><li>Ramie Fiber Woven Composite: The Effect of Feedrate Variation on the Tensile Strength of the Open Hole in the Drilling</li><li>Mathematical Model of Shear Stress Transfer at Fiber-Matrix Interface of Composite Material</li><li>Study on the Mechanical Properties and Behavior of Corrugated Cardboard under Tensile and Compression Loads</li><li>Chapter 3: Materials and Processing Technologies in Photovoltaics and Mechatronics</li><li>Conductive Glass with Simple Spray Deposition Method for Dye-Sensitized Solar Cell Application</li><li>Semiconductor TiO2 Coating Deposited by Microwave Plasma Method</li><li>Fabrication of Chemotaxis Microfluidic Device Mould Using Digital Light Processing 3D Printing Method</li><li>Chapter 4: Materials in Construction</li><li>Shear Strength Analysis of Rock due to the Effect of Surface Roughness Based on Laboratory Testing and Numerical Modeling</li><li>External Shear Strengthening of RC Beams with Anchored Geopolymer Fiber Mortar Panel: An Experimental Study</li><li>Failure Mode of GFRP Bar RC Beams Using GFRP Sheet as Shear Reinforcement</li><li>Strength Development of Seawater Mixed and Cured Concrete with Various Replacement Ratios of Fly Ash</li><li>Study on some Properties of Sustainable Mortar Incorporating Processed Waste Tea Ash</li><li>Investigation of Depth Variations of the Bamboo Twigs for its Acoustical Performance</li><li>The Sound Absorption Characteristics of Bamboo Twigs Based on Surface Combination Patterns</li><li>The Utilization of Geopolymer Mortar as Permanent Formwork in Reinforced Concrete Beam</li><li>Assessment of Stone Ash as a Fine Aggregate Material to Meet the Value of Normal Concrete Compressive Strength</li><li>Sound Absorption Coefficient Analysis for Composite Made of Agricultural Waste</li><li>Chapter 5: Structural Mechanics</li><li>Analytical and Experimental Study for Vibration of Laminated Rectangular Plates with Point Masses</li><li>Accurate Results by the Ritz Method for Free Vibration of Uniform Annular Plates</li><li>The Critical Load on Quadrilateral and Circular Hollow Pipes under Pure Bending and Pure Torsion</li><li>Laboratory Testing and Numerical Analysis on Reinforced Concrete Frames with Prefabricated Cellular Lightweight Concrete (CLC)</li><li>A Study of Alternative Materials for Sail Mast of Sandeq</li></ul>