2016 the First International Conference on Civil Engineering and Materials Science

<ul><li>Preface, Committees</li><li>Chapter 1: Analysis Properties and Production of Cements and Concretes</li><li>Influence of Fly Ash and Basalt Fibers on Strength and Chloride Penetration Resistance of Self-Consolidating Concrete</li><li>Rheological Optimization of Self Compacting Concrete with Sodium Lignosulfate Based Accelerant Using Hybrid Neural Network-Genetic Algorithm</li><li>Error Estimation of Linear Polarization Resistance Measurement Caused by IR Drop for Reinforcement Corrosion in Concrete</li><li>Belite Cement Prepared from High Carbon-Content Fly Ash</li><li>Uncertainty Analysis in Fatigue Life Prediction of Concrete Using Evidence Theory</li><li>Effect of Cement on the Engineering Properties of Pavement Materials</li><li>Relationships for Size and Dispersion of Pores with Mix Factors for Cement Sand Mortar</li><li>Chloride Ion Diffusion Model of the Concrete under Multiple Factors</li><li>Experimental Study on Hematite Concreting</li><li>Study of the Technical Capability of Sugarcane Bagasse Ash in Concrete Production</li><li>Effect of Substitution of Crushed Waste Glass as Partial Replacement for Natural Fine and Coarse Aggregate in Concrete</li><li>Structural Properties of Concrete Containing Ground Waste Clay Brick Powder as Partial Substitute for Cement</li><li>Effects of Concrete Mix Proportion on Electrical Resistivity of Concrete</li><li>Economic Exploitation of Gravel in Place of Granite in Concrete Production</li><li>Influence of Portland Cement Brands and Aggregates Sizes on the Compressive Strength of Normal Concrete</li><li>Performance Using Boiler Ash Clinkers as Replacement for Course Aggregates in Concrete</li><li>Influence of Mineral Admixtures on Fracture Energy of Refractory Cement at Elevated Temperatures</li><li>Research on Physical and Hydration Heat Characteristics of the Multi-Component Cementitious Materials</li><li>Durability of Red Mud Based Geopolymer Paste in Acid Solutions</li><li>Chapter 2: Design and Analysis Properties of Structures</li><li>Structural Behaviour of Ferrogeopolymer Slabs under Flexure</li><li>Effects of Carbon Fiber Reinforced Polymer Strips on the Flexural Strength and Deflection of Steel I-Beam</li><li>Seismic Upgrading of a Masonry Church with FRP Composites</li><li>Laboratory Tests of Reinforced Concrete Beams with the Use of Operational Modal Analysis</li><li>Influence of the Anchorage of PBO-FRCM Composites on the Effectiveness of Behaviour of Shearing Beams</li><li>The Reliability Analysis of the Initiation Time for RC Members under Chlorine Salt Ingress and Local Micro-Climate</li><li>Structural Damage Assessment of FRP Strengthened Reinforced Concrete Beams under Cyclic Loads</li><li>Producing High Strength Hollow Core Reinforced Concrete Slab with Silica Fume and Polypropylene Fibers</li><li>Chapter 3: Material Properties and Processing Technologies</li><li>Impact of Tool Pin Geometry and Optimized Process Parameters on Mechanical Properties of Friction Stir Welded AZ80A Mg Alloy</li><li>Synthesis Route of ZnO Nanostructures in Basic Solution</li><li>Effect of Hydroxyl Concentration on the Structural and Optical Properties of Zinc Oxide Nanoparticles</li><li>Antibacterial Properties of Unique Urchin-Like CuO Nanostructures by Chemical Bath Deposition</li><li>Development of Photocatalytic Self-Cleaning Cotton Fabric</li><li>Influence of Gel Aging Time on the Properties of Various Silica Aerogels Synthesized from Water Glass</li><li>Rapid Densification of Forsterite Ceramic via Microwave Sintering</li><li>Identification of Kinematic Hardening Material Parameters for Martensitic Steel Sheets</li><li>Cyclic Voltammetric Study of the Pitting Corrosion Behavior of Low-Nickel Austenitic Stainless Steels in Citric Acid</li><li>Effect of Temperature and Cooling Rate on the Microstructures of 35MnB and 25Mn Tubes during Heat Treatment</li><li>Empirical Modeling of Sound Absorption Properties of Natural Nonwoven Fabric (<i>Antiaris toxicaria</i> Barkcloth)</li><li>Plane Waves of Dilatation in Auxetic Bulk Solids</li></ul>