Manufacturing Engineering and Process V

<ul><li>Preface, Committee</li><li>Chapter 1: Testing and Analysis of Materials Properties</li><li>Fractograpic Observations and Effect of Stress Ratio on Fatigue Striations Spacing in Aluminium Alloy 2024 T351</li><li>Corrosion Behavior of Cr-Mo Alloy Steel in Direct Contact with Elemental Sulfur</li><li>Research on Salt Spray Corrosion of DM Code Laser-Marked on Aluminium Alloy</li><li>Symmetric Electrodes for Solid Fuel Cells Based on Sr-Doped LaFe_0.7Ni_0.3O_3-?</li><li>Structural and Morphological Analysis of Nanocomposite SnO₂-Graphene Synthesized by Sol-Gel Method</li><li>Analysis of Stresses and Displacements of Thin Coating Structures</li><li>Chapter 2: Technologies of Processing and Synthesis</li><li>Ultrasonic-Assisted Milling of Hard-to-Cut Materials: Development and a Framework for Further Investigations</li><li>Investigation of Curing Silver Conductive Inks on Fabrics Using DLP Projector and Hot Plate</li><li>Occupational Safety and Health Risk Assessment in Engineered Nanoparticles Manufacturing Processes</li><li>Micro-Hardness and Compression Strength of Particle Sizes Recycling Aluminium Alloy AA6061 Using Powder Metallurgy Method</li><li>Effect of Texturing on the Friction Characteristic of Carbide and Steel Material by Grinding Process</li><li>FEM and Contour Method Study of Quenching Residual Stress of 7050 Aluminum Alloy Cross-Shaped Component</li><li>Synthesis of Catechin-Gelatin Nanofiber by Electrospinning</li><li>Synthesis and Physicochemical Characterization of Mg-Al-Flufenamate-Layered Double Hydroxide</li><li>Development of an Antagonistically Actuated Smart Joint</li><li>Liquid Conductivity Sensor Based on AgPd Paste Fabricated on an Al₂O₃ Substrate Using Screen Printing Technique</li><li>Effect of 4% Cu Addition to Commercially Pure Aluminum Grain Refined by 0.15% V on its Ductility and Surface Roughness</li><li>Effect of 4% Cu Addition to Commercially Pure Aluminum Grain Refined by 0.15% V on its Mechanical Behavior, Fatigue Life and Strength</li><li>Evaluation of the Effect of Infill Pattern on Mechanical Stregnth of Additively Manufactured Specimen</li></ul>