Structural and Protective Materials

Preface
Chapter 1: Properties and Processing Technologies of Metals and Alloys
Laser Spot Welding a Three-Layered Panel in Different Spatial Positions
Determination of New Plasticity Characteristic of Alloys at Mechanical Compression and Tensile Tests and the Influence of Structural Factors on Plasticity
Electrochemical Hydrogenation Properties of New YNi3 and YNi4 Based Alloys
Electronic Structure of Tl4CdI6: First-Principles Calculations and X-Ray Photoelectron Spectroscopy Measurements
Numerical Analysis Nucleation and Growth Conditions of Single-Crystallinity Control during Laser Surface Modification of Ni-Based Single-Crystal Superalloy Part I: Thermal and Chemical Determinants
Effect of Solution Temperature on Microstructure and Properties of Mg-2Zn-0.5Zr-1.5Dy Alloy
Bayesian Network Modelling: Predictor Impact Assessment in Surface Roughness Prediction
Evaluation of Hardness Distributions around Fracture Surface in Induction-Heated SUJ2 Steel after Rotating Bending Fatigue Test
Non-Uniform Deformation of Slab during Heavy Reduction Process
Manufacturing of Complex-Shape PM Products Consisting of Several Powder Elements
Deformation, Strain and Stress Concentration of Slab Narrow Side Induced by Different Reduction Amount
Study on Cracks of Last Freeze in Al-Mg Alloy Flat Ingots
Effect of Heat Treatment Temperatures on Microstructure and Mechanical Properties of Continuous Casting and Rolling Al-Mg Alloy
Effect of Natural Surface Defects on Flaking Failure of 13Cr-2Ni-2Mo and SUS 440C Stainless Steel Ball Bearings
Hierarchical Clustering of Surface Roughness Using Acoustic Emission Signals
Numerical Analysis Growth Kinetics of Dendrite Tip during Laser Welding Nickel-Based Single-Crystal Superalloy Part II: Expedient Favorite of Undercooling-Limited Epitaxy
Chapter 2: Corrosion Protection
Preparation of Film-Forming Amine Emulsion as Boiler Water Treatment Agent
Influence of a Micro-Arc Oxidation/Poly-Lactic Acid Composite Coating on Corrosion Resistance of Extruded Mg-2Zn-0.5Zr-1.5Dy (Mass%) Alloy
Chapter 3: Protective Coatings
Thermal Spraying of MCrAlY Overlay Coating Using New Ethanol-Fueled HVOF Gun
The Formation of Two-Layer YSZ Ceramic Coatings Produced in Single Step PS-PVD Process
Structure and Wear Behavior of (Ti,Cr)C-Ni Detonation Sprayed Coatings
Chapter 4: Polymers, Composites and Ceramic Materials
Phase Equilibrium in the Ternary Ce?2-La2O3-Yb2O3 System at 1500 degrees?
New Low-Temperature Method of Synthesis of Boron Carbide Matrix Ceramics Ultra-Dispersive Powders and their Spark Plasma Sintering
X-Ray Structural and Spectroscopic Analysis of the Structure of Antifriction Wood-Polymeric Composite Materials Based on High-Density Polyethylene
Weibull Distribution to Evaluate the Reliability of PEEK Thrust Bearings under Rolling Contact Fatigue in Water
Research on the Tribological Properties of Polyoxymethylene - 40Cr
Preparation and Properties of B-Doped Silicon Carbide
Research and Analysis on the Micro-Morphology of Hollow Alumina-Based Fibers Prepared by Using Reeds as Templates
The Structure and Properties of Quartz Pore Gradient Ceramic Materials
Effect of Sintering Aids on Performance of Manganese Tailings Permeable Bricks