Advances in Reinforced Soil Structures

Proceedings of the 1st GeoMEast International Congress and Exhibition, Egypt 2017 on Sustainable Civil Infrastructures
 
 
Springer (Verlag)
  • erschienen am 11. Juli 2017
  • |
  • VIII, 161 Seiten
 
E-Book | PDF mit Adobe-DRM | Systemvoraussetzungen
E-Book | PDF mit Wasserzeichen-DRM | Systemvoraussetzungen
978-3-319-63570-5 (ISBN)
 

Soil reinforcement is a very useful technique to construct several cost-effective soil structures in an environmentally friendly and sustainable manner. The most commonly used reinforcement materials are galvanised steel strips, geosynthetics in the form of woven geotextiles, geogrids and geocomposites, and fibres from natural and waste products. In recent years, there have been advances in the area of soil reinforcement, especially in the utilization of the technique in field projects. The researchers have also been working to understand the behaviour of reinforced soil considering the field challenges of reinforced soil structures.

This edited volume contains contributions on advances in reinforced soil structures, mainly flexible pavements, footings, embankments, stone columns/piles, and slopes, as covered in the subject areas of geosynthetic engineering and fibre-reinforced soil engineering. The first paper by Ioannis N. Markou presents the details of sand-geotextile interaction based on interface tests with conventional and large-scale direct shear equipment. The second paper by Atef Ben Othmen and Mounir Bouassida examines the interface properties of geosynthetic reinforcement by carrying out inclined plane tests under low confinement adapted to landfill covers conditions. The third paper by J.N. Jha, S.K. Shukla, A.K. Choudhary, K.S. Gill1 and B.P. Verma deals with the triaxial compression behaviour of soil reinforced with steel and aluminium solid plates in horizontal layers. The fourth paper by M. Muthukumar and S.K. Shukla describes the swelling and shrinkage behaviour of expansive soil blended with lime and fibres. The fifth paper by S.G. Shah, A.C. Bhogayata and S.K. Shukla provides the test results of shear strength of cohesionless soil reinforced with metalized plastic waste. The sixth paper by Bouacha Nadjet compares the geotextile-reinforced and geogrid-reinforced flexible pavements based on numerical analyses.

The seventh paper by S. Kumar, C.H. Solanki, J.B. Patel, P.B. Sudevan and P.M. Chaudhary reports the results of laboratory model tests carried out on a square footing resting on prestressed geotextile reinforced sand. The eighth paper by Sanoop G and Satyajit Patel presents the numerical studies on ground improvement using geosynthetic reinforced sand layer. The ninth paper by ------------------- discusses the bearing capacity prediction of inclined loaded strip footing on reinforced sand by ANN. The tenth paper by Mohamad B.D. Elsawy presents the numerical simulation of an embankment, constructed on reinforced soft soil with conventional stone piles. The eleventh paper by N.O. Sheta and R.P. Frizzi deals with the analysis, design, construction and monitoring of a geosynthetics-reinforced-earth pile-supported embankment serving as an access road. The twelfth paper by S. Banerjee, A. Adhikari, S. Chatterjee and D. Das provides the details of a case study on reinforced slope on soft soil for the approach of a major bridge. We do hope the researchers and the engineers may find the contributions in this volume very useful. This volume is part of the proceedings of the 1st GeoMEast International Congress and Exhibition on Sustainable Civil Infrastructures, Egypt 2017.

1st ed. 2018
  • Englisch
  • Cham
  • |
  • Schweiz
Springer International Publishing
  • 120 s/w Abbildungen, 25 farbige Tabellen
  • |
  • 120 schwarz-weiße Abbildungen, 25 farbige Tabellen, Bibliographie
  • 31,75 MB
978-3-319-63570-5 (9783319635705)
10.1007/978-3-319-63570-5
weitere Ausgaben werden ermittelt
Dr. Sanjay Kumar Shukla is the Founding Editor-in-Chief of International Journal of Geosynthetics and Ground Engineering. He is an Associate Professor and Program Leader of Civil and Environmental Engineering at the School of Engineering, Edith Cowan University, Perth, Australia. He holds adjunct/distinguished professorship in civil engineering at three Indian universities, namely, VIT University, Chitakara University and Amrita University. He is an internationally recognized expert in the field of Civil (Geotechnical) Engineering, and has over twenty years of teaching, research and consultancy experience. His research interests include geosynthetics and their applications, fibre-reinforced soils, ground improvement, soil-structure interaction, soil dynamics, rock engineering, pavement engineering, and mining and environmental geotechnics. He is the author of popular ICE textbooks titled 'Core Principles of Soil Mechanics' and 'Core Concepts of Geotechnical Engineering', and has authored/co-authored/edited other 7 books and 12 book chapters. He is also the author/co-author of more than 170 research papers and technical articles, including over 100 refereed journal publications. He is a fellow of Engineers Australia, Institution of Engineers (India) and Indian Geotechnical Society, and a member of American Society of Civil Engineers (ASCE), International Geosynthetics Society, Indian Roads Congress and some other professional organisations. He is a Senior Editor of Cogent Engineering, a Scientific Editor of Journal of Mountain Science, and a Topical Editor of Mechanical Sciences. He serves on the editorial boards of International Journal of Geotechnical Engineering, Ground Improvement, Geotechnical Research, Indian Geotechnical Journal, Journal of Geotechnical and Transportation Engineering, and Advances in Civil Engineering.
Dr. Erol Guler is a full professor of geotechnical engineering at Bogazici University, Istanbul, Turkey since 1989. He acted as the Director of Environmental Sciences Institute of Bogazici University between 1996 and 1999 and as the Chairman of the Civil Engineering Department between 2004 and 2010. He was a visiting Fulbright Professor at the University of Maryland between 1989 and 1991. Prof. Guler is the leading geosynthetic scientist in Turkey, having been an IGS Member since 1989. He founded the IGS Turkish Chapter in 2001 and served as its president until 2005, and was reelected as President again in 2011. He was the organizer for the first two national geosynthetic conferences in 2004 and 2006 and is currently the chairman of the 7th congress which will be held in 2017. He was also of the Chairman of the 2016 European Regional Conference of IGS, EuroGeo6. Prof. Guler has been a member of the International Standards Organization (ISO) Technical committee on geosynthetics as a representative of the Turkish Standards Institute since 2002. He is currently the Convener of the WG2 of ISO/TC221 (Technical Committee on geosynthetics) and is also the Convener of the WG2 of CEN-TC189 (European Committee for Standardization's Technical Committee on geosynthetics). Prof. Guler is currently an international member of the USA TRB Committee on Geosynthetics. Prof. Guler's research has focused mainly on geosynthetic reinforced walls and specifically he conducted research on the use of marginal soils in such structures and their behavior under earthquake loading conditions. His research work includes numerical studies as well as shaking table tests and full scale tests. Prof. Guler has over one hundred scientific publications. In addition to his research work, Prof. Guler has extensive practical experience, including design work for numerous projects where geosynthetics were used as reinforcement or liners.
Direct Shear Testing of Sand - Geotextile InterfacesConsideration of geosynthetic tension in interpretation of data from inclined plane testsStress -Strain Behaviour of Sand with Disc Plate-Shaped ReinforcementSwelling and Shrinkage Behaviour of Expansive Soil Blended with Lime and FibresFEASIBILITY OF UTILIZATION OF METALIZED PLASTIC WASTE IN COHESION-LESS SOILComparison of geotextile-reinforced and geogrid-reinforced flexible pavements by numerical analyses.Study on square footing resting on prestressed geotextile reinforced sandNumerical Studies on Ground Improvement Using Geosynthetic Reinforced Sand LayerBearing capacity prediction of inclined loaded strip footing on reinforced sand by ANNSoft Soil Improvement with Conventional and Geogrid-encased Stone Piles under an EmbankmentAnalysis and Design of Piled Geogrid-Reinforced-Earth EmbankmentCase Study on GeoTrel® Reinforced Earth® Steepened Slopes on Soft Founding Soils for the Approach of Major Bridge over River Kaljani at CoochBehar in West Bengal, IndiaPrediction of Ultimate Bearing Capacity of Eccentrically Loaded Rectangular Foundations using ANN
Dewey Decimal Classfication (DDC)

Dateiformat: PDF
Kopierschutz: Adobe-DRM (Digital Rights Management)

Systemvoraussetzungen:

Computer (Windows; MacOS X; Linux): Installieren Sie bereits vor dem Download die kostenlose Software Adobe Digital Editions (siehe E-Book Hilfe).

Tablet/Smartphone (Android; iOS): Installieren Sie bereits vor dem Download die kostenlose App Adobe Digital Editions (siehe E-Book Hilfe).

E-Book-Reader: Bookeen, Kobo, Pocketbook, Sony, Tolino u.v.a.m. (nicht Kindle)

Das Dateiformat PDF zeigt auf jeder Hardware eine Buchseite stets identisch an. Daher ist eine PDF auch für ein komplexes Layout geeignet, wie es bei Lehr- und Fachbüchern verwendet wird (Bilder, Tabellen, Spalten, Fußnoten). Bei kleinen Displays von E-Readern oder Smartphones sind PDF leider eher nervig, weil zu viel Scrollen notwendig ist. Mit Adobe-DRM wird hier ein "harter" Kopierschutz verwendet. Wenn die notwendigen Voraussetzungen nicht vorliegen, können Sie das E-Book leider nicht öffnen. Daher müssen Sie bereits vor dem Download Ihre Lese-Hardware vorbereiten.

Bitte beachten Sie bei der Verwendung der Lese-Software Adobe Digital Editions: wir empfehlen Ihnen unbedingt nach Installation der Lese-Software diese mit Ihrer persönlichen Adobe-ID zu autorisieren!

Weitere Informationen finden Sie in unserer E-Book Hilfe.


Dateiformat: PDF
Kopierschutz: Wasserzeichen-DRM (Digital Rights Management)

Systemvoraussetzungen:

Computer (Windows; MacOS X; Linux): Verwenden Sie zum Lesen die kostenlose Software Adobe Reader, Adobe Digital Editions oder einen anderen PDF-Viewer Ihrer Wahl (siehe E-Book Hilfe).

Tablet/Smartphone (Android; iOS): Installieren Sie die kostenlose App Adobe Digital Editions oder eine andere Lese-App für E-Books (siehe E-Book Hilfe).

E-Book-Reader: Bookeen, Kobo, Pocketbook, Sony, Tolino u.v.a.m. (nur bedingt: Kindle)

Das Dateiformat PDF zeigt auf jeder Hardware eine Buchseite stets identisch an. Daher ist eine PDF auch für ein komplexes Layout geeignet, wie es bei Lehr- und Fachbüchern verwendet wird (Bilder, Tabellen, Spalten, Fußnoten). Bei kleinen Displays von E-Readern oder Smartphones sind PDF leider eher nervig, weil zu viel Scrollen notwendig ist. Mit Wasserzeichen-DRM wird hier ein "weicher" Kopierschutz verwendet. Daher ist technisch zwar alles möglich - sogar eine unzulässige Weitergabe. Aber an sichtbaren und unsichtbaren Stellen wird der Käufer des E-Books als Wasserzeichen hinterlegt, sodass im Falle eines Missbrauchs die Spur zurückverfolgt werden kann.

Weitere Informationen finden Sie in unserer E-Book Hilfe.


Download (sofort verfügbar)

139,09 €
inkl. 7% MwSt.
Download / Einzel-Lizenz
PDF mit Adobe-DRM
siehe Systemvoraussetzungen
E-Book bestellen

139,09 €
inkl. 7% MwSt.
Download / Einzel-Lizenz
PDF mit Wasserzeichen-DRM
siehe Systemvoraussetzungen
E-Book bestellen