Advanced Technologies in Material Processing

 
 
Trans Tech Publications Ltd (Verlag)
  • erscheint ca. am 20. August 2020
 
  • Buch
  • |
  • Softcover
  • |
  • 142 Seiten
978-3-0357-1655-9 (ISBN)
 
This volume contains papers presented at the International Conference on Experimental and Computational Mechanic in Engineering (ICECME, Indonesia, 18-9 September 2019) in conjunction with 9th AIC 2019 International Conference which reflect the last research results and engineering decisions in the area of materials science and technologies of materials processing.
  • Englisch
  • Zurich
  • |
  • Schweiz
Trans Tech Publications
  • Für Beruf und Forschung
  • Höhe: 240 mm
  • |
  • Breite: 170 mm
  • |
  • Dicke: 7 mm
  • 380 gr
978-3-0357-1655-9 (9783035716559)
10.4028/www.scientific.net/DDF.402
weitere Ausgaben werden ermittelt
Role of Size of Rubber Particles on Failure Mode and Impact Resistance Characteristics of PC/ABS Blends and their ABS Constituents with a Higher Rubber ContentProperties of High Strength Concrete with Calcined Diatomaceous Earth as Cement Replacement under CompressionInvestigation of Meniscus Effect on Microbond Test of Typha Fiber/Epoxy MatrixStudy on Fracture Failures of the Super Heater Water Pipe BoilerThermal Spray Application on the Dissimilar Metals Weld between Aluminum and SteelFatigue Life Assessments of the SAE 5160 Carbon Steel Subjected to Uphill and Downhill Roads StrainsFatigue Life Assessments of the AISI 1513 Carbon Steel Subjected to Road Surface StrainsFatigue Life Assessments of the AISI 1513 Carbon Steel of a Vehicle Lower Arm Subjected to Clockwise and Counter-Clockwise Road StrainsFlexural and Splitting Tensile Strength of High Strength Concrete with Diatomite Micro Particles as Mineral AdditiveInfluence of Forestry and Agriculture By-Products as Filler Materials on Thermal Conductivity of Fiberboard Panels Applied for Heat-Conditioned Building Partition WallThe Effect of Rotation Speed and Dwell Time on the Zn Distribution of the Dissimilar Metals Friction Stir Spot Welded between Aluminum Alloy and Galvanized SteelThe Effect of Process Route on the Mechanical Properties and Microstructure Aluminum Al-Si-Cu-Mg-Mn AlloysEffect of Machining Parameters on Hole Accuracy and Burr Formation in Micro-Drilling of BrassOptimization of Machining Process Parameters Using Moora MethodNumerical Simulation of the Effect of Shoulder Rotation on the Tensile Strength of FSW Dissimilar Joints of Aluminum AlloyEffect of Different Gating Systems and Sand Mold Binder on the Cast-Quality of Bicycle Frame Produced through Sand Casting MethodThe Investigation of Hole Delamination in Drilling Kevlar Composite Panel Using HSS Drill ToolThe Preparation and Characterization of Fe-ZnO Nanoparticles Immobilized onto Fiberglass ClothThe Effect of Spindle Speed and Feed Rate on Hole Diameter of High-Speed Micro-Drilling for Micro-Screen Manufacture

Noch nicht erschienen

171,73 €
inkl. 7% MwSt.
Vorbestellen